Hello, I'm searching for a good USB 3 hub for Linux for use at work. I know just about everything will be compatible with Linux (the first native USB3 driver OS) which I use frequently at home with enough built-in ports without a hitch. I am curious if anyone has had better success with some USB 3 hubs over others? My primary goal is high, maintained speed and throughput. I do a lot of forensic imaging (drive to drive copying over USB 3), so four ports would be sufficient, and a separate power hub is a no brainer. I use dc3dd, guymager + libewf, and ftkimager, the latter two being threaded and very fast for compression and encryption. I know ideally I should be using eSATA for this, but there are other reasons for not doing it that way. Price isn't too much of a sticking point since it's covered by work, but I don't want to go all out with a pink rhinestone $200 4 port USB 3 hub either ;-) I noticed Micro Center has some options (am open to online locations as well): http://www.microcenter.com/search/search_results.aspx?N=0&NTX=&NTT=usb+3+hub&NTK=all&sortby=rating Any suggestions (general experience, benchmarks, etc) are greatly appreciated, -- Jeremy MountainJohnson Jeremy.MountainJohnson at gmail.com -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://mailman.mn-linux.org/pipermail/tclug-list/attachments/20130130/220712bf/attachment-0001.html>