I am trying to set up mrtg to monitor an HP Procurve 
<http://www.tek-tips.com/viewthread.cfm?qid=1648083&page=1#> 2919al 
switch that has a couple vlans on it. I can ping the vlan 1 ip 10.0.1.1, 
but cfgmaker willmar at 10.0.1.1 -output=config times out, as well as 
snmpwalk -v 1, 2c, and 3 10.0.1.1

I have removed the snmp community 
<http://www.tek-tips.com/viewthread.cfm?qid=1648083&page=1#> (willmar) 
and recreated it as unrestricted, but nothing seems to work.

Other Procurve switches work fine that are setup the same way.

Any ideas?

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.mn-linux.org/pipermail/tclug-list/attachments/20110511/4d7a1bb9/attachment.html>