Usually those IRQ's are set automatically at boot time; however, why not try giving it (manually setting) the IRQ to 11. Ideally, if you can get the correct driver for it, your troubles should go away. Normally, wake on LAN is nothing more than minimal power to the card. > Got F2 (kernel 2.6.5-1.358) installed on my Presario 2100 and > dual-booting well with the original XP (BootItNG did the trick for > repartitioning the NTFS). But the modem doesn't work (Linuxant says they > have a driver) and the ethernet card won't do anything. It's the > built-in NatSemiconductor DP83815/816 10/100 MacPhyter PCI. It's eth0 > and I've given it static IP of 192.168.0.11 and everything seems to be > fine. During boot it comes up and the Network GUI reports it "ok" and > "active". But the hub light is dead and no pinging gets through. Same > ethernet works perfect when I boot to XP. One tell-tale thing is on shut > down it reports "remaining active for wake-on-lan". Another odd thing is > according to the GUI, it gives "unknown" as the IRQ address. XP says > it's 11. Any ideas? > > Olwers > > > _______________________________________________ > TCLUG Mailing List - Minneapolis/St. Paul, Minnesota > Help beta test TCLUG's potential new home: http://plone.mn-linux.org > Got pictures for TCLUG? Beta test http://plone.mn-linux.org/gallery > tclug-list at mn-linux.org > https://mailman.real-time.com/mailman/listinfo/tclug-list > _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota Help beta test TCLUG's potential new home: http://plone.mn-linux.org Got pictures for TCLUG? Beta test http://plone.mn-linux.org/gallery tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list