Monday, April 21, 2003   @   11:20:21 PM Central Standard Time

PM> It's due to fire code and NEC (National Electric Code.)  Even low voltage
PM> cables have the potential (no pun intended) of starting fires.  The thing is 
PM> that you never know what the failure mode of the box it's hooked up to will 
PM> be -- if a computer suffers AC death syndrom and puts 120VAC on the ethernet 
PM> cable, it could be a bad thing.

Also, not just hardware failure is the concern.  Non-Plenum should be
run through conduit. Plenum is made for use without conduit (like
Romex for electrical) due to fire retardant/non-toxic-burn coating,
and it's a little more bad ass in nature, as
mentioned earlier.  If you had non-plenum cables running
through out an office building/multiple floors not in conduit (just hanging
above drop ceilings, through vent. ducts, between walls, etc..) and a
fire breaks, your entire network cabling can act like a big fuse.
Say a coffee maker starts on fire (cause unknown), and a pc is next to
it.  The coffee maker burns (unnoticed)and starts the pc on fire.
Someone sees the burning coffee maker/pc & rushes to grab a fire
extinguisher.  The pc burns and your cost-cutting non-plenum
haphazardly wired cat 5 cable starts to burn.  The employee returns
with a fire extinguisher, and puts out the fire, or so he(or she)
thinks.  While the employee was franticly trying to put out the small
blaze, the flame started moving down along the non-plenum cable, and
secretly burned it's way into the wall, where the cable drops down
two floors into an old wiring closet.  This would have been a small
stupid fire, and contained had the proper cable been installed.
As it burns its way down the cable, it is having a great time
igniting anything flammable in its
path (and kicking out some Saddam Approved toxic gas too).  You can imagine
how the story goes from there.  Death & destruction to all in it path,
and then it reaches the wiring closet.  When burning starts in the
closet, it ignites all the other el-cheapo cables in their, and the
process of burning up or down the cable begins again.  Oh no!!!(terror
strikes) You ran a non-plenum cable from the main closet
threw a sewer across the street to your other
buildings closet. and boom....another towering inferno.

Here is a more proper def:
Commercial constructions often use suspended ceilings as return passages for environmental air. These "plenum" spaces have become convenient wiring locations for a variety of applications. However, use of these areas may pose a serious hazard in the event of a fire. Once the fire reaches the plenum space, few barriers exist to contain the smoke and flames.  The National Fire Protection Association (NFPA) has recognized the potential for a hazard created by wire and cable in an environmental air space. Severe restrictions on cabling were included in the 1975 edition of the NEC. All
following NEC editions set forth safety requirements for flammable insulations. The National Electric Code (NEC) states that all cabling not in conduit, installed in plenum spaces, shall be listed as having adequate fire-resistant and low smoke-producing characteristics.

Rock-On,

Robert (aka B_o_B) David Felix De Mars
West Longitude 90' 15' 43"
http://b-o-b.homelinux.com
mailto:chewbaka at toughguy.net



_______________________________________________
TCLUG Mailing List - Minneapolis/St. Paul, Minnesota
http://www.mn-linux.org tclug-list at mn-linux.org
https://mailman.real-time.com/mailman/listinfo/tclug-list