> When I burn a disc with my ATAPI burner, the burn goes just fine until the > end where it fixates the disc. Then I get an Input/Output error which says > Illegal SCSI Request. I read something about the scsi generic driver not > emulating the scg devices as well as they should, and that's why I get the > error. > > So what do I do? The discs I burn don't work because the TOC never gets > written. I've seen this happen when: 1. Using media designed for 8x in 16x mode. (i.e. incompatible media) 2. Trying to use "Disk at Once" copying on a burner that only supports "Track at once". I would see if this occurs in a simulated write. If it is being caused by one of these two reasons, then it will fail in a simulation too. =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- What the president of the Motion Picture Association of America says about taking away your constitutional rights: "I'm rather jubilant now. What Judge Kaplan did was blow away every one of these brittle and fragile rebuttals. He threw out fair use; he threw out reverse engineering; he threw out linking." - Jack Valenti, president of the Motion Picture Association of America. =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- ______ _ __ "If you don't have the freedom to use what you / ' ) ) own - then you do not own anything." / o ______ / / _ . . No apologies to Jack Valenti or the MPAA / <_/ / / < / (_</_(_/_ -- tneu at visi.com / http://www.visi.com/~tneu --