No, it is a Rockwell HCF 56K V90 FaxModem. ScanMan wrote: > Ummm... If it's PCI, it's probably one of the infamous WinModems. You > could try looking about on http://www.linmodems.org/, but don't get your > hopes up. > > On Sun, 2001-12-16 at 18:04, Perry Hoekstra wrote: > > I have a question on modem detection. I installed a modem on a RH7.2 > > system. Upon bootup, Kudzu detected the modem and configured the > > modem. If I do a lspci, I see the modem in the listing. How do I > > figure out which /dev/ttyS* it is parked on. I have going through the > > Linux Modem-HOWTO. I tried probing using setserial but all it tells me > > is that I have UART 16550A on ttyS0, ttyS1 and unknown on ttyS2 and > > ttyS3. Is there a file that Kudzu wrote the configuration to or when > > setserial is run on startup? I looked in the standard places such as > > serial.conf but there was no joy. > > > > -- > > Perry Hoekstra > > E-Commerce Architect > > Talent Software Services > > perry.hoekstra at talentemail.com > > > > > > _______________________________________________ > > Twin Cities Linux Users Group Mailing List - Minneapolis/St. Paul, Minnesota > > http://www.mn-linux.org > > tclug-list at mn-linux.org > > https://mailman.mn-linux.org/mailman/listinfo/tclug-list > > > > _______________________________________________ > Twin Cities Linux Users Group Mailing List - Minneapolis/St. Paul, Minnesota > http://www.mn-linux.org > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list -- Perry Hoekstra E-Commerce Architect Talent Software Services perry.hoekstra at talentemail.com