You wrote earlier that you swapped power supplies and your board didn't work, but now you say it is a power supply that was causing you trouble. No offense intended, but did you REALLY swap cables as well, or are you assuming your cables are fine without swapping them? Try a new cable. Try reseating your cards and try a different PCI slot. Try a different port on the hub. Make all these changes one at a time, so you know what change caused the problem to go away if it does. Tom Veldhouse veldy at veldy.net ----- Original Message ----- From: "Miller, John" <JMiller2 at dainrauscher.com> To: <tclug-list at mn-linux.org> Sent: Sunday, August 12, 2001 5:34 PM Subject: [TCLUG] NIC Card > I wrote earlier this week about my mb dying. After further trials, it > still lives. I took the system apart so I could get to the connector > better and plugged it in and it worked. The ps died. > > Now I have my system reassembled and the NIC that I use to connect to > the internet seems not to be working. Drivers for both cards are > loaded. /proc/pci lists them both When I plug the cable in, the link > light comes on on the back of the card but does not light up the hub. I > have swap the the cord on the hub, nothing. When I bring eth0 up with > ifconfig eth0 up, I get all the information. > > The card is a netgear FA311. It has served me well. > > Anyone have any ideas, > > TIA > > John Miller > _______________________________________________ > tclug-list mailing list > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list >