OK. I don't have the correct kernel module. Syslog looks like this: Apr 26 09:08:36 merlin cardmgr[180]: executing: 'modprobe -r serial_cs' Apr 26 09:09:04 merlin cardmgr[180]: initializing socket 0 Apr 26 09:09:04 merlin cardmgr[180]: socket 0: ATA/IDE Fixed Disk Apr 26 09:09:04 merlin cardmgr[180]: executing: 'modprobe ide_cs' Apr 26 09:09:04 merlin cardmgr[180]: + modprobe: Can't locate module ide_cs Apr 26 09:09:04 merlin cardmgr[180]: modprobe exited with status 255 Apr 26 09:09:04 merlin cardmgr[180]: module /lib/modules/2.4.3/pcmcia/ide_cs.o not available Apr 26 09:09:06 merlin cardmgr[180]: get dev info on socket 0 failed: Resource temporarily unavailable I am using the 2.4.3 kernel built using make-kpkg under debian. I guess the question is what is the config setting that builds the ide_cs module? (I think the card would show up as hdc as I don't believe my laptop has 2 IDE channels...just my guess anyway.) Thanks, Dave On 25 Apr 2001 17:05:34 -0500, Andy Zbikowski wrote: > The high-low been indicates that the card was detected but something didn't > initlize. (Driver didn't load, etc.) > > 1> What kernel are you running? > 2> Any error messages in dmesg, or /var/log/syslog > 3> Are you sure it's /dev/hdc? Your hard drive will be /dev/hda, cdrom might > be /dev/hdb but could be /dec/hdc... > I'd think that the PCMCIA would be an off board IDE controller, this show up > as /dev/hde, but I could be wrong. > > >From the sounds of it, you need to check your logs for errors and solve > those errors. > > -- > Andy Zbikowski, Sys Admin | (WEB) http://www.ltiflex.com > LTI Flexible Products, Inc. | (PH) 763-428-9119 (EX) 132 > 21801 Industrial Blvd | (FX) 763-428-9126 > Rogers, MN 55374 | (PCS) 612-306-6055 > _______________________________________________ > tclug-list mailing list > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list