This is my first attempt at using a tape backup on a Linux/UNIX system and I am in need of some help. I am faced with having to take whatever I can find out of a box of of old equipment and find a tape backup solution where I work. I have searched through all of the Linux HOW-TOs that I could find and haven't come up with anything. Here's exactly where I am at... Have one one (apparently working) BusLogic BT-946C PCI SCSI card. I have found this card on RedHat's list of Tier 1 supported SCSI adapters. I have one HP internal DDS2 tape drive with part number C1539-69201. I haven't found the common name for it yet. I also have one HP external SureStore Tape 6000 drive. I only need one of these to work. I thought I would go with the internal unit as that is known to be functional and more 'out-of-the- way' I installed the SCSI card into a Mandrake 7.0 system I am going to use for testing purposes. Kudzu found the new hardware and correctly identified it and configured it. I then rebooted with the internal drive connected to the SCSI card and the system booted normally without any mention of new hardware. I am not sure if it should have 'discovered' the drive or not. Question: How do I communicate with this tape drive? It is the only SCSI device in the system and I have no experience with SCSI devices. I need to figure out how to mount it somehow so I can use dd, cpio, tar, etc. to write to it. Would Amanda be a good tool to use? If anyone could point me to some how-tos or web sites that could help I would appreciate it. I may pick up the O'Reilly book 'Unix Backup and Recovery' in the next day or two - I think that it could be valuable considering my level of expertise at the moment. Thank-you, Mike Glaser --------------------------------------------------------------------- To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org For additional commands, e-mail: tclug-list-help at mn-linux.org